> For the complete documentation index, see [llms.txt](https://docs-origin.anvil.bot/llms.txt). Markdown versions of documentation pages are available by appending `.md` to page URLs; this page is available as [Markdown](https://docs-origin.anvil.bot/reference/technical-reference/custom-message-types.md).

# Custom Message Types

For some of our data, we define custom ROS2 message types. You can work with these trivially by re-defining them in your own code, using the official definitions below as reference

## CommandedEEPose

```
# CommandedEEPose.msg
# End-effector command: target pose + gripper opening.
# Pose is expressed in `header.frame_id` (typically "world").
# `gripper` is the target gripper joint position in metres,
# gripper range is [-0.003, 0.05].
std_msgs/Header header
geometry_msgs/Pose pose
float64 gripper
```

## MotorStatus

```
std_msgs/Header header

# Motor name (corresponding to URDF/JointState name)
string[] name

# Controller ID (Feedback Frame: MST_ID)
uint8[] can_id

# -----------------------------------------
# Status and Error Codes
# -----------------------------------------
# Corresponds to the ERR field in the Feedback Frame (High 4 bits)
# Detailed code definitions:
#   0   (0x0)  : Disabled
#   1   (0x1)  : Enabled
#   8   (0x8)  : Overvoltage
#   9   (0x9)  : Undervoltage
#   10  (0xA)  : Overcurrent
#   11  (0xB)  : MOSFET Overheating
#   12  (0xC)  : Motor Coil Overheating
#   13  (0xD)  : Communication Loss (Watchdog Timeout)
#   14  (0xE)  : Overload
uint8[] status_code

# -----------------------------------------
# Thermal Monitoring
# -----------------------------------------

# Indicates the average temperature of the drive MOSFET (Feedback Frame: T_MOS)
# Unit: °C
uint8[] temp_mos

# Indicates the average temperature of the motor’s internal coil (Feedback Frame: T_Rotor)
# Unit: °C
uint8[] temp_rotor

# -----------------------------------------
# Raw Feedback Data - For Debugging
# -----------------------------------------
# These data are usually converted to standard units (rad, rad/s, Nm) and published to the /joint_states topic.
# These fields are reserved for debugging "Linear Mapping" conversion formulas or checking if raw CAN values are abnormal.

# Raw Position (POS) (16 bit) - Value before mapping
uint16[] position_raw

# Raw Velocity (VEL) (12 bit) - Value before mapping
uint16[] velocity_raw

# Raw Torque (T) (12 bit) - Value before mapping
uint16[] torque_raw

```
